Ipf 900xs installation

Just behind the head light the black and green white wires. Never would have found that firewall hole without the pointer mentioned above. I was more than disappointed with the lackluster instructions that came with these high quality lights so this site saved us a bunch of time. Hi Thanks for the instructions, my lights came with just a vague diagram and yours were pretty clear and i seem to have got it right except that the lights dont switch on with the high beams, you know what that might be?

I routed the wires in the electro-tap as shown.. Anyone know how to wire up off road lights to turn off when the high-beams are turned on? Dumb question I know but here in VA they have to be set up like that or they get removed during inspection.

Great job. I do have a question however. I have an 06 TJ that I am replacing the factory driving lights with Sx lights, using the original location. I wondering however, if I can use the original jeep wiring. The jeep lights have a 55 watt bulb and the sx have a 65 watt bumb. Will I be over taxing the original wiring if I use it? Thanks so much for this writeup! Great recommendation on using the side marker lights.

Thanks again! I cannot figure out how to take the light grill off so that I can change the bulb. Currently you have JavaScript disabled. In order to post comments, please make sure JavaScript and Cookies are enabled, and reload the page. Click here for instructions on how to enable JavaScript in your browser. However, you will need to have brackets that you can mount them to on your Jeep JK Wrangler bumper, windshield or light bar. You will need an appropriate bracket on your bumper, windshield or overhead bar to mount them onto.

You will need a 19mm wrench to secure them in place. Pop open the hood of your your Jeep JK Wrangler and route the long wiring harness to wherever you need it to go.

Attach the pair of black ground leads with brown ticks extending from the IPF XS lights to the ground stud and secure them in place using the factory nut. A 10mm wrench will be needed for this job. Attach the single black ground lead with brown ticks extending from the relay plug on to the ground stud and secure it in place using the factory nut.

Attach your IPF XS yellow power lead to the positive mounting stud and secure it in place using the factory nut. Open the passenger side door and remove the air vent baffles by rotating it and pulling it out as shown. It is intend to be out of date, but still bright and gentle light in the eyes. D High Intensity Discharge, it the new replacement technology for halogen headlights. Brightness is the biggest advantage of an HID conversion.

Not only will you be able to see farther and better at night, but other drivers will be able to see as well. LEDs are more expensive than traditional bulbs. They are heat sensitive, so if they are not used with a steady and consistent current, they can stop working or fade quicker. These lights are also usually best used in directional lighting rather than room lighting, although some changes in design may improve this.

It is the unit of the optical energy generated from an electric bulb.